AMBER Archive (2009)Subject: [AMBER] AMBER 10 output
From: Sergey Samsonov (sergeys_at_biotec.tu-dresden.de)
Date: Tue May 19 2009 - 02:33:21 CDT
Dear AMBERs,
I have AMBER 10 installed and it runs properly. Previously I used AMBER
8 version and I found a difference in output writing: the whole output
file (.out) is written after the run is completed and not by each step
of writing. Is it possible to change so that I could look at output
file each ntpr number of steps as it was by default in AMBER 8?
Thank you and best regards,
Sergey
_______________________________________________
AMBER mailing list
AMBER_at_ambermd.org
http://lists.ambermd.org/mailman/listinfo/amber
|